BILLET STEEL HYDRAULIC ROLLER CAMSHAFT
This part is no longer available.
M-6250-C580T
Instruction Sheet
Not Available
WARNING:
This part is designed and intended for competition use only or off-highway use only. It should not be installed on a vehicle that is driven on public roads and highways. Installation of this part on a vehicle driven on public roads and highways is likely to violate U.S. and Canadian laws and regulations relating to motor vehicle emissions.
The C580T cam was developed by Ford Performance. It's a dual pattern cam with a strong lumpy idle that makes good power from 3,000 through 6,500 RPM. This is a true street-strip cam and works best with a manual transmission or higher stall speed torque converter and high numerical rear end gears. Works well with carburetors or mass air fuel injection.
- Billet steel hydraulic roller camshaft
- Camshaft lift (in): .580"/.602" with 1.65:1 rocker ratio - .563"/.584" with 1.6:1 rocker ratio
- Camshaft duration (@.050 in): 232 degree/240 degree
- 112 degree lobe separation and 107 degree intake valve centerline
- Ford Performance M-6500-R302H High Performance Hydraulic Roller Lifters are recommended in factory roller cam blocks
- Manual transmission or higher stall torque converter (3,000 RPM) recommended for automatic transmission
- Fits 1985-2000 302, 1994-97 351W roller cam blocks, Ford Performance Boss 302 and Boss 351 race blocks.
- Will also fit non-roller cam 289, 302 and 351W blocks when used with tie-bar aftermarket hydraulic roller lifters
- Requires upgraded valve springs.
- Check valve to piston clearance
Part Type
Engine: Cam/Tappets/Pushrods
Warranty Availability
Not Available
Package Dimensions
4" x 3.5" x 29.5"
Package Weight
10.6 lb(s)
UPC Code
756122000632
Country of Origin
United States