2.0L ECOBOOST ENGINE AND CONTROL PACK KIT
This part is no longer available.
M-9000-20TK
Instruction Sheet
Not Available
WARNING:
This part is designed and intended for competition use only or off-highway use only. It should not be installed on a vehicle that is driven on public roads and highways. Installation of this part on a vehicle driven on public roads and highways is likely to violate U.S. and Canadian laws and regulations relating to motor vehicle emissions.
This value priced kit includes the 2.0L Focus ST EcoBoost engine kit and M-6017-20T Control Pack to run the engine.
The M-6007-20T Engine Kit kit includes:
- EcoBoost Engine from 2013-2014 Ford Focus ST
- Production rating of 252 Horsepower @ 5,500 RPM
- Production rating of 270 lb. ft. of torque @ 3,000 RPM
- When used with Ford Performance Control Pack M-6017-20T and 93 octane unleaded fuel, torque is increased 90 lb. ft at 2800 RPM - with a significant increase up to 4200 RPM. See the power curve for PN M-6017-20T
- All-aluminum construction - about 55 pounds lighter than a comparable naturally aspirated V6 engine
- 9.3:1 compression ratio - Premium fuel recommended
- Ti-VCT Strategy Employs twin independent variable camshaft timing for optimized fuel economy, performance and emissions
-
Borg-Warner Turbocharger with low-inertia rotor spins at speeds up to 195,000 rpm, producing up to 16 psi of boost
- Optimized design ensures that maximum torque is achieved at very low engine revs
- Peak torque available from 2,000 to 4,500 rpm
-
Direct-Injection high-pressure fuel system
- Seven jets on each injector spray fuel directly into the combustion chamber
-
Engine design has been optimized for maximum operating efficiency, with a focus on minimizing friction and other parasitic losses
- Low-friction coatings on the piston rings and highly polished surfaces on the tappets
- Engine Kit Includes:
- Starter
- Alternator
- Front accessory drive and belt
- Intercooler and air intake ducting
- Air Cleaner Assembly
- Manual Transmission flexplate/flywheel
- M-6017-20T Control Pack includes:
- Unique control pack harness replaces stock body harness and is designed for custom built vehicle. Harness includes OBD-II diagnostic port to assist in vehicle calibration upload and problem diagnosis.
- Includes PCM with Ford Performance hi-performance calibration
- Includes Electronic Throttle Control accelerator pedal, eliminating throttle cable routing problems
Part Type
Engine: Complete Engines
Warranty Availability
Package Dimensions
36" x 65" x 36"
Package Weight
490.9 lb(s)
UPC Code
756122002391
Country of Origin
United States